Best Plumbing Contractors in Richmond Hill, ON
6 plumbing contractors found in Richmond Hill
Jay Home Renovation
Richmond Hill, ON
Ratings aggregated by AI and may contain inaccuracies.
Tetra Group Corporation
Richmond Hill, ON
Ratings aggregated by AI and may contain inaccuracies.
Shirazz contracting inc.
Richmond Hill, ON
Ratings aggregated by AI and may contain inaccuracies.
Green home and design
Richmond Hill, ON
Ratings aggregated by AI and may contain inaccuracies.
Asri Design & Build
Richmond Hill, ON
Ratings aggregated by AI and may contain inaccuracies.
HKM renovation
Richmond Hill, ON
Ratings aggregated by AI and may contain inaccuracies.
How much does plumbing cost in Richmond Hill?
Most Canadian homeowners pay $150-$450 for a common plumbing repair - clearing a drain, or swapping a toilet or faucet - on top of a $90-$350 service-call fee, with plumbers billing about $80-$175 an hour. Bigger equipment jobs cost far more: a replacement water heater runs roughly $1,100-$6,500 depending on tank versus tankless, and a sump pump $500-$2,500.
In Richmond Hill, ON, typical quotes tend to come in above the Canadian average, so the table below nudges these national figures up by roughly 15% at the low end of each range and up to 30% at the top end.
What moves the price: The low end is a common repair like clearing a drain or swapping a toilet or faucet; the top end is equipment work like a tank or tankless water heater or a sump pump.
| Project | Typical cost in Richmond Hill |
|---|---|
| Service call / diagnostic visit (covers travel + first 30-60 min) | $180 $100 to $450 per visit |
| Standard hourly labour rate (regular hours) | $150 $90 to $225 per hour |
| Drain cleaning / snaking (sink, toilet or main line) | $325 $170 to $775 per project |
| Toilet installation / replacement (incl. removal and disposal) | $425 $225 to $650 per project |
| Faucet installation / replacement (kitchen or bathroom) | $375 $170 to $600 per project |
| Water heater - tank (supply + install, gas or electric) | $2,300 $1,300 to $3,900 per project |
| Water heater - tankless (supply + install, all-in) | $6,000 $2,900 to $8,500 per project |
| Sump pump installation / replacement (pedestal or submersible) | $1,500 $575 to $3,300 per project |
What changes the price of plumbing in Richmond Hill
- Home age and access: older homes with corroded shut-off valves, worn toilet flanges, outdated pipe materials, or tight crawlspaces and finished basements add labour time.
- Scope of the actual fix: a quick drain snake costs a fraction of a camera inspection plus hydro-jetting or a main-line dig; a straight water-heater swap costs far less than one needing new gas line, venting or electrical.
- Permits and inspection: some municipalities require permits or a safety inspection (for example TSSA sign-off on gas work in Ontario), which add fees and a bit of time.
- Bundling jobs: combining several small tasks into one visit usually saves 10-20% because the plumber reuses the trip and setup time.
- Timing of the visit: emergency, after-hours, weekend and holiday calls typically run 1.5x to 2x normal rates, with emergency call-outs often $180-$300 per hour.
- Quality of the fixture or equipment: a builder-grade toilet or faucet costs far less than a high-end or touchless model, and gas vs electric or condensing vs non-condensing water heaters swing the price by thousands.
How plumbing prices vary across Canada
Big metros cost more. Toronto and Vancouver run roughly 15-25% above the national ranges - Vancouver plumbers commonly bill $120-$180/hr and Toronto $100-$200/hr versus an $80-$150 national norm, and Toronto drain cleaning is quoted $250-$600 versus $150-$350 nationally. Calgary, Edmonton and Ottawa land about 10-15% above baseline. Montreal, mid-size cities and the Prairies are near the national average, and rural and Atlantic Canada often sit slightly below.
These are typical Richmond Hill-area price ranges based on 2026 Canadian market data, not quotes. Your actual cost depends on the size and details of your project. Post your project on Bidmii to get free quotes from the 6 plumbing contractors listed in Richmond Hill above.
Frequently Asked Questions about Plumbing in Richmond Hill
How much does plumbing cost in Richmond Hill?
The cost of plumbing services in Richmond Hill, ON varies depending on the scope of work. Post your project on Bidmii to receive free, competitive quotes from local professionals.
How do I find a licensed plumbing contractor in Richmond Hill?
Browse our directory of plumbing contractors in Richmond Hill above. Look for contractors with the Verified badge, which means their identity has been confirmed. You can also check ratings aggregated from multiple platforms.
How many plumbing contractors are in Richmond Hill?
Bidmii currently lists 6 plumbing contractors in Richmond Hill, ON. Our directory is growing — create a free listing if you're a contractor.
How much does a plumber charge just to show up?
A service call is usually $90-$350, which typically covers travel and the first 30-60 minutes of diagnosis. After that, most Canadian plumbers bill $80-$175 per hour. Evening, weekend and emergency visits cost noticeably more.
Is a tankless water heater worth the extra cost over a tank?
Tankless costs roughly 2 to 3 times more upfront (about $2,500-$6,500 installed vs $1,100-$3,000 for a tank), but it lasts around 20 years instead of 10-12 and uses roughly 20-30% less energy. It pays off if you plan to stay in the home long term; a straight tank swap is the cheaper choice if budget is the priority.
Why is my drain cleaning quote so different from my neighbour's?
It comes down to the blockage. A simple sink or toilet snake is often $150-$300, but a deep main-line clog that needs a camera inspection or hydro-jetting can run $400-$600 or more. Where you live matters too, since big-city rates run higher.