Best Millwork Contractors in Kitchener, ON
20 millwork contractors found in Kitchener
Cicada Woodworks
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Jay Martin Flooring
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
westmount craftsmen inc
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Weir Woodworks and finishing
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Covach Construction
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Garcia Enterprises
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Jam flooring and contracting
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Aesthetic & electric
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Choob Carpentry
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
JM Renovations & Services
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
K & S Woodworking
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
AYO construction
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Ivan Turtsanash
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Kyle McCann Contracting
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Spur Line Contracting
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Speedy Sparkle
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Radu Painting
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Freelance
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
Alexandra Jasinski
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
F&S Floor Installations
Kitchener, ON
Ratings aggregated by AI and may contain inaccuracies.
How much does millwork cost in Kitchener?
Most homeowners spend $900-$2,500 on a typical carpentry and trim job - a room or two of new baseboards and casing, or a set of interior doors (installed doors run about $500-$700 each, and trim roughly $8-$13 per linear foot). A single-door swap or small trim touch-up starts around $300, while custom built-ins, closets, or whole-home millwork packages run $4,000-$12,000 or more.
In Kitchener, ON, typical quotes tend to track the Canadian average, so the table below shows these national figures unchanged.
What moves the price: The low end is a single door swap or a small trim touch-up; the top end is custom built-ins, closet systems and whole-home millwork packages.
| Project | Typical cost in Kitchener |
|---|---|
| Baseboard & trim installation (supply + install) | $8-$10 $6 to $13 per linear foot |
| Whole-room trim package (baseboard + door/window casing, one room) | $900-$1,200 $600 to $1,600 per room |
| Crown molding installation | $14 $8 to $25 per linear foot |
| Custom built-in bookcase / shelving unit | $4,500 $1,500 to $12,000 per project |
| Wainscoting / trimmed feature wall | $20 $12 to $40 per square foot |
| Interior door installation (door + install labour) | $500-$700 $250 to $1,000 per door |
| Custom closet / mudroom storage built-in | $4,000 $1,500 to $10,000 per project |
| Finish carpenter labour rate | $70 $50 to $95 per hour |
What changes the price of millwork in Kitchener
- Finishing scope - whether the quote includes caulking, filling nail holes, sanding and painting/staining, or just raw installation. Paint or stain finishing adds roughly $1-$4 per linear foot.
- Custom vs. off-the-shelf built-ins - a fully site-built cabinet with doors, drawers, lighting and glass costs several times more than trimming out a premade or IKEA-based unit to look built-in.
- Site access and removal - tearing out old trim, protecting finished floors, high ceilings needing scaffolding, and hauling away debris all push the price up.
- Material grade - pre-primed MDF, pine and PVC are the cheapest; stain-grade hardwoods like oak, maple and walnut cost several times more per foot and are less forgiving to install.
- Profile complexity and height - tall baseboards, multi-piece 'built-up' crown, and intricate or layered profiles take far more cuts, coping and fitting time than simple flat stock.
- Wall and corner condition - out-of-square corners, wavy old plaster, and lots of inside/outside corners mean more scribing and fussing, which adds labour hours (the biggest cost in finish work).
How millwork prices vary across Canada
Toronto and Vancouver run the highest, followed by Calgary, Ottawa and Victoria, and the premium is almost entirely on labour rather than materials. Interior door labour, for example, runs $50-$150 more per door in Toronto and Vancouver than in smaller markets. Because finish carpentry is labour-heavy, the big-city premium shows up strongly in this trade.
These are typical Kitchener-area price ranges based on 2026 Canadian market data, not quotes. Your actual cost depends on the size and details of your project. Post your project on Bidmii to get free quotes from the 20 millwork contractors listed in Kitchener above.
Frequently Asked Questions about Millwork in Kitchener
How much does millwork cost in Kitchener?
The cost of millwork services in Kitchener, ON varies depending on the scope of work. Post your project on Bidmii to receive free, competitive quotes from local professionals.
How do I find a licensed millwork contractor in Kitchener?
Browse our directory of millwork contractors in Kitchener above. Look for contractors with the Verified badge, which means their identity has been confirmed. You can also check ratings aggregated from multiple platforms.
How many millwork contractors are in Kitchener?
Bidmii currently lists 20 millwork contractors in Kitchener, ON. Our directory is growing — create a free listing if you're a contractor.
What's the difference between finish carpentry and framing carpentry?
Framing (or rough) carpentry is the hidden structure - walls, subfloors, roofs. Finish carpentry is the visible detail work: baseboards, casing, crown, wainscoting, built-ins and doors. Finish work is billed higher per hour because it has to be precise, clean and paint-ready.
How much does it cost to replace baseboards and trim in one room?
Budget roughly $600 to $1,600 for an average room, or about $6 to $13 per linear foot including materials and labour. Simple pre-primed MDF sits at the low end; tall stain-grade hardwood with painting included lands at the high end.
Is a custom built-in worth it compared with buying a bookshelf?
A site-built custom unit ($1,500-$12,000+) costs more than freestanding furniture, but it fits wall-to-wall and floor-to-ceiling, adds real storage and resale appeal, and won't tip or leave gaps. If budget is tight, many carpenters can trim out a cheaper prefab or IKEA cabinet so it looks built-in for less.