Best Carpentry Contractors in Cambridge, ON
32 carpentry contractors found in Cambridge
Fox Haven Contracting
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Straightline Improvements Inc
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
D&S Construction Group
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
JorLex Contracting
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
MODERN TRANSFORMATION
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Silver Maple Maintenance
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Golden Triangle Restoration
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Tripple J Cleaning
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Brazen Beaver Manufacturing and Design
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Wendels renovations
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
H & A Designs
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Picasso Contracting
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Gateway Village Homes
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
RENOX BUILDING SUPPLIES INC.
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Mirza Asad
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Descon Renovations Inc
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Kann home solutions
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Silver Maple Renovations Inc.
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
Nathan D Carr AKA The Lone Roofer
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
DeslandesConstruction
Cambridge, ON
Ratings aggregated by AI and may contain inaccuracies.
How much does carpentry cost in Cambridge?
Most homeowners spend $900-$2,500 on a typical carpentry and trim job - a room or two of new baseboards and casing, or a set of interior doors (installed doors run about $500-$700 each, and trim roughly $8-$13 per linear foot). A single-door swap or small trim touch-up starts around $300, while custom built-ins, closets, or whole-home millwork packages run $4,000-$12,000 or more.
In Cambridge, ON, typical quotes tend to track the Canadian average, so the table below shows these national figures unchanged.
What moves the price: The low end is a single door swap or a small trim touch-up; the top end is custom built-ins, closet systems and whole-home millwork packages.
| Project | Typical cost in Cambridge |
|---|---|
| Baseboard & trim installation (supply + install) | $8-$10 $6 to $13 per linear foot |
| Whole-room trim package (baseboard + door/window casing, one room) | $900-$1,200 $600 to $1,600 per room |
| Crown molding installation | $14 $8 to $25 per linear foot |
| Custom built-in bookcase / shelving unit | $4,500 $1,500 to $12,000 per project |
| Wainscoting / trimmed feature wall | $20 $12 to $40 per square foot |
| Interior door installation (door + install labour) | $500-$700 $250 to $1,000 per door |
| Custom closet / mudroom storage built-in | $4,000 $1,500 to $10,000 per project |
| Finish carpenter labour rate | $70 $50 to $95 per hour |
What changes the price of carpentry in Cambridge
- Material grade - pre-primed MDF, pine and PVC are the cheapest; stain-grade hardwoods like oak, maple and walnut cost several times more per foot and are less forgiving to install.
- Profile complexity and height - tall baseboards, multi-piece 'built-up' crown, and intricate or layered profiles take far more cuts, coping and fitting time than simple flat stock.
- Wall and corner condition - out-of-square corners, wavy old plaster, and lots of inside/outside corners mean more scribing and fussing, which adds labour hours (the biggest cost in finish work).
- Finishing scope - whether the quote includes caulking, filling nail holes, sanding and painting/staining, or just raw installation. Paint or stain finishing adds roughly $1-$4 per linear foot.
- Custom vs. off-the-shelf built-ins - a fully site-built cabinet with doors, drawers, lighting and glass costs several times more than trimming out a premade or IKEA-based unit to look built-in.
- Site access and removal - tearing out old trim, protecting finished floors, high ceilings needing scaffolding, and hauling away debris all push the price up.
How carpentry prices vary across Canada
Toronto and Vancouver run the highest, followed by Calgary, Ottawa and Victoria, and the premium is almost entirely on labour rather than materials. Interior door labour, for example, runs $50-$150 more per door in Toronto and Vancouver than in smaller markets. Because finish carpentry is labour-heavy, the big-city premium shows up strongly in this trade.
These are typical Cambridge-area price ranges based on 2026 Canadian market data, not quotes. Your actual cost depends on the size and details of your project. Post your project on Bidmii to get free quotes from the 32 carpentry contractors listed in Cambridge above.
Frequently Asked Questions about Carpentry in Cambridge
How much does carpentry cost in Cambridge?
The cost of carpentry services in Cambridge, ON varies depending on the scope of work. Post your project on Bidmii to receive free, competitive quotes from local professionals.
How do I find a licensed carpentry contractor in Cambridge?
Browse our directory of carpentry contractors in Cambridge above. Look for contractors with the Verified badge, which means their identity has been confirmed. You can also check ratings aggregated from multiple platforms.
How many carpentry contractors are in Cambridge?
Bidmii currently lists 32 carpentry contractors in Cambridge, ON. Our directory is growing — create a free listing if you're a contractor.
Is a custom built-in worth it compared with buying a bookshelf?
A site-built custom unit ($1,500-$12,000+) costs more than freestanding furniture, but it fits wall-to-wall and floor-to-ceiling, adds real storage and resale appeal, and won't tip or leave gaps. If budget is tight, many carpenters can trim out a cheaper prefab or IKEA cabinet so it looks built-in for less.
Do carpenters charge by the hour or by the project?
Both. Small jobs - a few doors, a repair, a shelf - are often billed hourly at roughly $50 to $95 per hour in Canada. Larger trim packages and built-ins are usually quoted as a flat project price after an on-site measure. Always get the finishing (caulk and paint) spelled out in the quote so it isn't a surprise add-on.
What's the difference between finish carpentry and framing carpentry?
Framing (or rough) carpentry is the hidden structure - walls, subfloors, roofs. Finish carpentry is the visible detail work: baseboards, casing, crown, wainscoting, built-ins and doors. Finish work is billed higher per hour because it has to be precise, clean and paint-ready.